Multitech Conduit - AEP
Multitech provides a wide variety of models for the Conduit platform. Most of these models are variations based on network connectivity and operating system; as such if you do not see your model listed, it is highly likely it will still work. We have verified the MTAC-LORA-H-915, MTAC-LORA-H-868, and MTAC-LORA-915 Gateway accessory cards; we strongly recommend the -H variants as they provide faster connectivity between the processor and the LoRa Concentrator.
|MultiConnect Conduit AEP||AEP 1.4.3+|
|MultiConnect Conduit AP - AEP||AEP 1.4.3+|
|MultiConnect Conduit IP67 - AEP||AEP 1.4.3+|
It is strongly recommended to use an mLinux Conduit. If an AEP conduit will be used for development only, please upgrade to AEP version 1.4.3 or higher.
Senet Packet Forwarder for Developers
Verify Version Compatibility
AEP Conduit version 1.4.1 is not compatible with Senet Gateway Software. If your Gateway is running this version, please upgrade to AEP 1.4.3 or greater before installing Senet Gateway Software. MultiTech AEP Software and complete upgrade instructions are available at: http://www.multitech.net/developer/downloads/
Determine the MultiTech Conduit Type and Serial Number
The MultiTech Conduit Part Number is listed on the bottom of the Gateway. Example:
If the Part Numbers contains
210L, the type is mLinux Conduit. If the Part Numbers contain
210A, the type is Application Enablement (AEP) Conduit.
The Serial Number is 8-Digits and found on the bottom of the Conduit Gateway.
Multitech provides instructions for configuring the backhaul network interfaces, including WiFi and cellular, on their website at http://www.multitech.net.
Disable Basic LoRa Network Server
In order for the Senet Gateway Software to operate correctly the basic LoRa Network Server that comes pre-installed on the Multitech MUST be disabled. Below you will find the instructions on how to disable this setting on two different Multitech models.
Navigate to the AEP Web Interface and select Setup->LoRa Network Server.
If enabled, uncheck the Enabled check box under LoraConfiguration.
Navigate to Setup->Time and enable SNTP
Additional information on the MultiTech AEP interface is available at: http://www.multitech.net
As a basic security precaution we ask that you change the default password of the Gateway to ensure basic security protection. For more information please refer to the documentation that came with your Gateway
Copy and paste the following command into the Conduit console.
Run the command, installation is automatic.
Once registration and Gateway software installation are complete the Gateway will be displayed in the Senet Portal Dashboard with the current registration status (this may require a refresh of the browser). For more information controlling the Senet Gateway Software, please refer to our Gateway FAQ.